Home > Published Issues > 2021 > Volume 10, No. 4, July 2021 >

Measurement Method for Erector Spinae Muscle Activity during Patient Handling Using Inertial Sensor and Shoe-type Force Sensor

Kodai Kitagawa 1, Koji Matsumoto 1, Kensuke Iwanaga 1, Siti Anom Ahmad 2, Takayuki Nagasaki 3, Sota Nakano4, Mitsumasa Hida 1,5, Shogo Okamatsu 1,6, and Chikamune Wada 1
1. Graduate School of Life Science and System Engineering, Kyushu Institute of Technology, Kitakyushu, Japan
2. Malaysian Research Institute of Ageing (MyAgeing™), Universiti Putra Malaysia, Selangor, Malaysia
3. Department of Rehabilitation, Tohoku Bunka Gakuen University, Sendai, Japan
4. Department of Rehabilitation, Kyushu University of Nursing and Social Welfare, Tamana, Japan
5. Department of Physical Therapy, Osaka Kawasaki Rehabilitation University, Kaizuka, Japan
6. Department of Physical Therapy, Kitakyushu Rehabilitation College, Kanda, Japan

Abstract—Because caregivers often experience lower back pain caused by lumbar load from patient handling, monitoring this load can help prevent pain. Erector spinae muscle activity, which is measured and monitored as lumbar load, is commonly measured by electromyography (EMG). However, EMG’s electrodes can cause skin irritation and be uncomfortable. Therefore, measuring muscle activity without electrodes is necessary. In this study, we propose a method for estimating erector spinae muscle activity using wearable sensors, specifically inertial and shoe-type force sensors. Inertial sensors measure acceleration and angular velocity of the trunk. Shoe-type force sensors measure vertical force of the feet. A regression model obtained from a machine learning algorithm can predict erector spinae muscle activity using inertial and force data. In our experiment, we evaluated the accuracy of our method by comparing sensor data with surface EMG data in patient handling. Results show that this method can measure erector spinae muscle activity with a small error (less than 5% maximal voluntary contractions) and a significantly high correlation with actual value (r = 0.891, p <0.05). In addition, a Bland-Altman plot showed no fixed and proportional errors. These findings indicate that our proposed method can accurately monitor the lumbar loads of caregivers. 
Index Terms—Erector spinae muscle, inertial sensor, lumbar load, machine learning, muscle activity, shoe-type force sensor

Cite: Kodai Kitagawa, Koji Matsumoto, Kensuke Iwanaga, Siti Anom Ahmad, Takayuki Nagasaki, Sota Nakano, Mitsumasa Hida, Shogo Okamatsu, and Chikamune Wada, "Measurement Method for Erector Spinae Muscle Activity during Patient Handling Using Inertial Sensor and Shoe-type Force Sensor," International Journal of Electrical and Electronic Engineering & Telecommunications, Vol. 10, No. 4, pp. 283-287, July 2021. Doi: 10.18178/ijeetc.10.4.283-287

Copyright © 2021 by the authors. This is an open access article distributed under the Creative Commons Attribution License (CC BY-NC-ND 4.0), which permits use, distribution and reproduction in any medium, provided that the article is properly cited, the use is non-commercial and no modifications or adaptations are made.